Cross roller bearing installation steps, people may not know too much, because there are too many types of bearings, we need to explain one by one, then today's cross roller bearing Xiaobian to everyone to explain is the cross roller bearing, cross roller When installing sub-bearings and installing cross-roller bearings, see the steps below.
1. Inspection of the parts before installation: Thoroughly clean the main shaft, bearing housing or other mounting parts to remove oil stains or impurities, and check for burrs or burrs.
2. Install the cross roller bearing into the shaft or bearing housing: Due to the thin-walled bearing, it tends to tilt when installed. In order to prevent this phenomenon, while maintaining the level, evenly beat with a plastic hammer, and carefully insert the cross roller bearing into the bearing seat or the shaft little by little until it is confirmed by sound that it is completely close to the reference surface.
3, the installation of fixed flanges:
(1) Place the mounting flange on the cross roller bearing. Shake the flange several times to match the bolt hole position.
(2) Insert the fixing bolt into the hole. When turning the bolt by hand, make sure that the bolt is not screwed in because of the deviation of the bolt hole.
(3) The tightening of the fixing bolts can be divided into 3-4 stages from incomplete locking to full locking, and tightening is repeated in the order of the diagonal lines. When tightening the inner or outer ring of the split body, turning the whole outer ring or inner ring slightly can correct the deviation between the inner and outer rings and the main body.
