Rebar connection sleeve must pay attention to the installation in use, this can avoid some unnecessary technical issues, thus affecting the quality of the rebar connection sleeve. 1. Rebars are in place: The rebars that pass the inspection of the wire are transported to the place to be connected. 2. Tighten the connector: Use a wrench or pipe wrench to tighten the connector. 3. Marking: Mark the joints that have been tightened and separate them from the untightened joints. 4, construction inspection: quality inspection of the finished joints. 5, bandage other rebar.
The technology of steel joint processing requires very stringent steps and requirements. We can compare the other processing technologies in terms of the technical steps of the steel joints. 1. Flat end of steel bar: The purpose of the flat end is to make the end face of the steel bar perpendicular to the axis of the parent metal, and declares that the cutting machine or other special cutting equipment is used, and gas cutting is prohibited. 2. Stripping rib rolling threads: Using the steel stripping rib rolling straight thread machine, the ends of the steel bars to be connected are processed into threads. 3, silk quality inspection: The operator of the processing of the silk head quality inspection. 4, with cap protection: with a special steel wire head protection cap or connecting sleeve to protect the steel wire to prevent the thread from being bumped or contaminated by dirt. 5. Stencil quality inspection: Sampling inspection of the self-tested silkhead. 6, storage for use: according to the specification model and type of classification code.
