The application of mining machinery and equipment in mining has been increasing along with the development of the economy. However, in order to ensure the normal level of mining machinery and equipment, it is essential for daily maintenance. So, what are the basic issues for daily inspection of mining machinery and equipment? According to the normal practice, the daily inspection of general mining machinery and equipment accessories should start from the following aspects:
1. Check the bearing. It is mainly to check whether the bearing lubrication is in place because it bears the full load of mining machinery and the degree of lubrication has a direct relationship with its service life. In addition, when adding lubricating oil must be kept clean, the usual storage of lubricating oil should pay attention to the seal; when the bearing temperature increases, there may be problems, and at this time to stop the failure.
Lift winch accessories
2. Check the newly installed tyre. Because it is a new tire, it has not yet fully worn out, so it is prone to loosening, so it must be checked frequently.
3. Check the parts that are easy to wear, especially after every working period, mainly check the parts. If the wear is serious, replace them in time to avoid affecting the work.
4. Check the cleanliness of the chassis. The plane of the base of the movable device shall be free from dust and other objects to prevent the movable bearings from moving on the base frame when the machine encounters unbreakable materials, resulting in serious accidents. The
5. Check the transmission gear. When the transmission gear is in operation, if there is impact noise, it shall immediately stop the inspection and remove the fault.
6. Check each part. In addition to the above-mentioned aspects, daily inspection and inspection of mining machinery and equipment also needs to pay attention to whether or not each component is working properly. This is a basic inspection to ensure normal operation.
