How to reduce the wear of rotary kiln

Rotary kiln is one of the more kiln we use in the kiln. It is inevitable that problems will occur after a long period of use, especially in the process of operation. Although this is not a major problem, it will cause great damage to the equipment after a long time. Therefore, we need to take some measures to reduce the wear of the furnace.
1. Lubrication of the drive unit
The lubrication of this part of the rotary kiln is mainly the lubrication between the gears. Since the pores between the gears are very limited, if graphite is used as the lubricant, it is not reasonable, but the injection lubrication method is adopted. How to avoid the vertical type needs attention. It is this kind of lubrication that requires the staff to check the injection status and confirm it in time.
2. Lubrication between the cylinder pad and the rolling ring
Graphite is very fluid and smooth, and is suitable for lubrication where a large amount of lubricant is required.
3. Lubrication of the support device
The lubrication of the rotary kiln rolling ring and the surface of the tug is relatively simple. The kiln parts are damaged. However, it should be noted that the size of the graphite block will change during the long-term work of the equipment. If the graphite block is found to be small, the maintenance personnel of the vertical kiln must It is necessary to replace the graphite in time, otherwise the desired lubrication effect will not be achieved.
The above is an introduction to the method of reducing the wear of the rotary kiln, which means that we can reduce the wear of the kiln by lubricating the main equipment of the kiln, like the drive and support, and the gap between some components. . This reduces wear and extends service life for longer-lasting operation.