Scrap crusher rotor structure:
The rotor of RG2026 scrap crusher consists of 1 spindle 12 hammer discs 2 hammer discs 6 hammer spindles 39 hammers 27 guard plates including 6 end guard plates to make up the rotor speed 595 r/min
It is a large, high-speed slender rotor. The RG2026 scrap crusher rotor is a typical high-speed slender rotor.
Its hammer end working circle outer edge Φ2000mm rotor body working length 2790mm hammer axis, 6 hammerheads are arranged in 6 rows and 11 columns. The average weight of the hammerhead is 131.7kg. The protection board is divided into common protection board and end protection board protection board. The average quality is 221kg. The end protection board is 6 pieces. The average quality is 255kg. The end protection board is to limit this part of the protection board can only be placed on both ends of the rotor.
When the steel crusher is hammering the hammer, it is generally necessary to first group the hammerheads and guard plates of different sizes and then group the positions according to the mass of each hammerhead. The mass arrangement of the position of the hammer on the rotor generally meets several principles:
1 The mass of the same radial plane of the rotors should be equal or close to each other;
2 The total mass of the axially symmetric mass of the working cylindrical surface of the rotor should be equal to or close to the maximum deviation not exceeding 020 kg;
