The machine is mainly composed of rotary body, lifting plate, transmission device, support device and sealing ring. The dryer is a cylinder slightly tilted with the horizontal direction. The material is fed from the higher end. The high-temperature hot flue gas enters the cylinder in parallel with the material. With the rotation of the cylinder, the material runs low due to the action of gravity. One end. A copy board is installed on the inner wall of the cylinder, and the materials are picked up and sprinkled again, so that the contact surface of the material and the air flow is increased to increase the drying rate and promote the advancement of the material. The dried product was collected from the bottom of the bottom. Widely used in chemical, mining, metallurgical and other industries, such as ore, slag, coal, metal powder, clay, diatomite, kaolin. Agriculture, feed and fertilizer industries such as straw, pasture, distiller's grains, dregs, pomace, soy sauce residue, bagasse, peat, organic compound fertilizer, sludge, aquatic product waste, food plant waste, slaughterhouse waste, organic fertilizer, Inorganic fertilizer, phosphate fertilizer ammonium sulfate.
【Dryer Aperture】Material: Usually use zg45, zg35crmo, 42crmo and other related materials, horizontal lathe finishing, tempering normalizing, the hardness is not less than HB170, the accuracy level meets the 9-9-8 in GB10095 Level standard.
【Dryer Aperture】Delivery: Standard parts are ready for delivery at any time, non-standard parts are delivered within 10-15 days.
【Dryer Aperture】 Price: The price is mainly affected by the heat treatment requirements of the casting's weight and the processing cost.
[Dryer aperture] role is to support the cylinder on the dryer supporting wheel, and can make the cylinder rotate smoothly at the set rotation speed on the supporting roller, so the material of the roller ring must meet the national standard. To have a certain degree of wear resistance and sufficient hardness.
[Dryer aperture] common size: Φ1.2 meters: 1450x1250x120, Φ1.5 meters: 1890x1650x120, Φ1.8 meters: 2190x1950x140, Φ2.2 meters: 2600x2368x220
Dryer drive components: Dryer gear, dryer forged pinion assembly, dryer shaft support roller assembly, signal wheel assembly, dryer cast steel diaphragm and so on.
The convention of the aperture of the dryer is not the same, some are called the wheel belt, the rolling ring, the running circle, etc. It is the indispensable transmission part for the normal operation of the equipment. It supports the normal rotation of the drum with the supporting roller, and the aperture of the dryer Heat treatment mainly has the following purposes: 1. Eliminate the stress caused by the previous processes and improve the mechanical processing performance of the steel. 2. Refine the microstructure and homogenize the metal particles. 3, increase the hardness of castings to enhance wear resistance and extend service life.
High-efficiency and energy-saving dryer product series Specification: Φ1.5x12m, Φ1.8x12m, Φ2.0x18m, Φ2.2x14m, Φ2.4x18m, Φ3.0x20m, Φ3.2x25m.
