Winding machne Category Editor
Winding machne Category Editor
Category Editor
Automatic type
With Japan as a pioneer, to meet the rising labor and product quality requirements of the high emergence of the aircraft. Through the motor, electric components, pneumatic components, transmission, sensors, control systems, such as a combination of a high degree of automation equipment. Can usually automatically cable, Tang Tou, broken line clip, twisting, loading and unloading. Operators only need to ensure that sufficient raw materials, in the absence of the workpiece or the timely replacement of copper to ensure continuous production, usually a higher number of axes in order to achieve efficient production. A machine with a high degree of automation meets the requirements of one employee to take care of multiple devices at the same time.
Advantages: Operators do not need training directly induction, production efficiency, product quality, long hours without interruption.
Disadvantages: the price is higher than the semi-automatic equipment, take a long time to recover the cost of generating benefits, you need to be equipped with technicians to ensure the operation of equipment, fault repair more complicated, more difficult to change the product range.
Suitable for mass production of single mature products.
Semi-automatic type
Is currently the most widely used winding machine, only to achieve automatic cable, the rest of the operation required to complete the operation. Usually fewer axes to meet the operator's operating time to facilitate the replacement of different molds to produce different products.
Advantages: cheap, some of the machinery can not be completed by the process can be completed, the device deviation can be adjusted by the operator compensation, easy to replace the product.
Disadvantages: the need to be equipped with more labor, employees need a certain degree of training, limited by the operator's proficiency in the operation.
Suitable for low-cost production, new product production, many kinds of small batch production.
In accordance with the winding method can be divided into: flat winding machine, ring winding machine, flying fork winding machine, three-dimensional winding machine.
Flat line machine
By the spindle rotation, with three-dimensional mobile positioning through the space, so that the outer wire in a spiral arrangement of the workpiece winding machine. Commonly used to process most transformers, inductors and various types of coils. It is currently the most widely used winding machine.
Ring type
By the spindle (storage wheel) rotation, with the auxiliary wheel action, so that the wire in a hollow round, hollow square or other similar workpieces in a spiral ring-type winding machine. It is usually used to process loop coils.
Flying fork type
By the side of the motor driven flying fork winding machine. Commonly used in winding wire winding and rotor winding process.
Three-dimensional type
Winding machine produced to suit the special winding mode of special products. Commonly used in the stator and special products winding process.
