There are many reasons for the low crusher production, such as the hardness, humidity, and fineness of the material to be broken, as well as the low yield due to the quality of the equipment itself.
Because the condition of the broken material to be produced is certain, that is, the hardness and toughness conditions of the material are fixed. In the process of using the crusher, the materials must be filled according to the instructions of the equipment; the humidity of the material is too large and the inside of the equipment is easy to adhere. , It is also easy to cause blockage in the process of material transportation, resulting in low efficiency of the equipment. If the material is too wet, it should be dried after processing, and then crushing work; the fineness of the material after grinding is required High, the abrasive capacity of the crusher is relatively reduced, resulting in inefficiency. For the equipment itself to fail, we need to find out and solve it accordingly.
The wiring position of the crusher motor is reversed, which affects the operation of the motor; the size of the discharge opening of the crusher is small, and the output of the crusher will also form a clogging of the discharge opening, so the size of the discharge opening needs to be adjusted; the liner of the crusher The phenomenon of shifting will also affect the working status and working efficiency of the equipment. It is necessary to ensure that the position of the liner is appropriate. After the crusher is used for a period of time, the liner structure and bearing wear increase the working gap, and the bearing rotates relative to the outer ring, resulting in production. Lower, you can always check the liner and bearing wear and replace it in time.
