1. The energy consumption rate of the ball mill is relatively low. At present, there is a tendency to be replaced by vertical mills, roller presses, etc., but the ball mill has a “granular shape that is approximately spherical, which is conducive to raw material calcination and cement hydration hardening”. The special advantage is that this is the main reason why clinker mills still use ball mills.
2. Because the vertical grinding mill method is reasonable, the grinding work is fully utilized by the materials, and the grading is timely, avoiding the phenomenon of over-grinding of the materials, so the grinding efficiency is high and the power consumption is low (20% less than the ball mill) the above).
3. The vertical roller mill allows a large amount of air to be passed, so the drying capacity is large; the material in the grinding is in a suspended state, which increases the contact area between the material and the airflow, and the heat exchange condition is good, so the drying efficiency is high. (When the ball mill grinds the wet material, due to its limited air flow through the ball mill, additional drying equipment is usually required in front of the ball mill.)
